The K-1705-3 provides a tough and attractive handsfree phone for apartment,
and residential door/gate entry or applications requiring a vandal resistant
speaker phone with built-in color CCTV video camera. When the “Call” button is
pressed, the K-1705-3 returns dial tone. The keypad may then be used to dial any
number. If no Touch Tone is entered within 8 seconds, CPC is detected, a busy
signal is detected, or the programmable maximum call time has elapsed, the
K-1705-3 will automatically disconnect. Alternatively, the K-1705-3 may be
disconnected by pressing the “Call” button again. The K-1705-3 features a
built-in high resolution color video camera, microphone and speaker volume
controls, selectable auto answer for monitoring, a yellow “In-Use” LED and comes
complete with a standard flush mount rough-in box. In addition, an optional
VE-6x7 weather resistant surface mount box is available. For extreme outdoor
environments or corrosive atmospheres, the K-1705-3 is available with Enhanced
Weather Protection (EWP). EWP products feature rubber gaskets and boots, closed
cell foam gasketing, hand soldered silicon sealed connections, anti-corrosive
gel filled butt connectors, as well as urethane encapsulated circuit boards with
internally sealed, field-adjustable trim POTS and DIP switches.
Specifications
Speaker K17053
Features
Built-in high resolution color video camera with wide viewing, tilt/swivel
adjustments and wide operating temperature of -30F to 150F
Audio and video transmission on one CAT5E cable
Vandal Resistant Features: 14 gauge louvered stainless steel faceplate with
stainless steel speaker/mic screen, heavy duty metal keypad and “Call” button,
impact and scratch resistant camera lens and hex drive mounting screws
Weather Resistant Features: Mylar speaker, faceplate gasket, mic and speaker
gasket, internally sealed (IP67) push button switch and keypad, sealed camera
lens, potted camera circuit board, stainless steel phone and camera mounting
hardware
Optional Enhanced Weather Protection (EWP) conforms to NEMA requirements
Yellow “in use” LED
Volume adjustments for microphone and speaker
Advanced call progress detection: disconnects on busy signal, return to dial
tone, CPC reorder tone, maximum call time out and selectable silence time out
Selectable auto-answer feature for monitoring
Selectable push button disconnect
Zinc plated steel rough-in box with (2) 3/4” conduit knockouts
Optional VE-6x7 surface mount box available
Selectable maximum call time
Selectable VOX switching speed
Entry Phone Specifications
Power: Telephone line powered 20V DC/20mA minimum
Dimensions: Overall: 140mm x 165mm x 66mm (5.5” x 6.5” x 2.6”) , Rough-in box:
114mm x 140mm x 64mm (4.5” x 5.5” x 2.5”)
Speaker Volume: Approximately 70 db maximum @1m
Ring Voltage: 25V AC RMS minimum (for auto answer)
CPC Disconnect Time: 500ms minimum
REN #: 0.5 A
Camera Specifications
Power: 5-9V DC regulated 150mA (6V DC adapter included)
Maximum Wire Run Length: 1000 ft with *RG59/RG6 for video and CAT5 for power
(doubled pairs) and entry phone audio. 150 ft with CAT5E for video, power and
entry phone audio
Entry Phone / Camera Specifications
Operating Temperature: -34 C to 65 C (-30 F to 150 F)
Humidity: Standard model: 5% to 95% non-condensing, EWP model: Up to 100%
Apartment entry phone when used with the K-1900-3 Apartment Entry Dialer
or C-4000 Apartment/Office Entry Controller or C-3000 Apartment Entry
Controller
Residential gate or door entry phone when used with the C-2000A Door
Entry Controller
Courtesy and customer assistance phone
Automated teller (ATM) phone
Security or emergency phone
Hot-Line phone when used with the K-1900-5 Hot-Line Dialer Note: When
installing a line powered phone on a low voltage and/or low loop current
phone system extension, a TBB-1A Talk Battery Booster may be required (Fax
Back # 630).
Kiosk phone with (100 number speed dialing) when used with the K-1900-9
Multi-Number Dialer
The
Technical Support Service
offered involves technical assistance by telephone and the Web for issues associated
with the products purchased from JSTQI.
Thoroughly trained on our products the support team has access to our real-time,
knowledge base and captive network models, which help them, replicate and resolve
problems while avoiding disruption of your network.
Please
call us for technical questions and support
Toll Free: 800.626.4670